APC Trade-UPS is a 1-phase UPS program that offers new and existing customers the ability to trade in older battery backup units for the most up-to-date 1-phase power protection models at discounted prices.
More about the program Program rulesRack PDU 2G, Switched, ZeroU, 20A, 208V, (7) C13 & (1) C19, L620 Cord
Rack PDU 2G, Switched, ZeroU, 20A, 208V, (7) C13 & (1) C19, L620 Cord
APC Switched Rack Power Distribution Units (PDUs) enable advanced, user-customizable power control and active monitoring. Remote outlet level controls allow power on/off functionality for power recycling to remotely reboot equipment and restrict unauthorized use of individual outlets. Power sequencing delays allow users to define the order in which to power up or down attached equipment. Avoid circuit overload during power recovery and extend uptime of critical equipment by prioritizing the load shedding. Current metering provides real-time remote monitoring of connected loads. Switched Rack PDUs include real power monitoring, a temperature/humidity sensor port, locking IEC receptacles, and low profile circuit breakers. User-defined alarms warn of potential circuit overloads before critical IT failures occur. Users can access, configure, and control Switched Rack PDUs through secure Web, SNMP, or Telnet Interfaces and is complimented by APC Centralized Management platforms using InfraStruxure Central, Capacity Manager and Change Manager.
Includes : Installation guide , Locking input power cord , Rack mounting brackets , Safety guide , Serial configuration cable
Antigua & Barbuda , Anguilla , Netherlands Antilles , Argentina , Barbados , Belgium , Bermuda , Bolivia , Bahamas , Belize , Canada , Chile , Colombia , Costa Rica , Serbia and Montenegro , Dominica , Dominican Republic , Ecuador , Grenada , Guatemala , Guyana , Honduras , Croatia , Haiti , Italy , Jamaica , St. Kitts & Nevis , Cayman Islands , St. Lucia , Morocco , Mexico , Nicaragua , Netherlands , Norway , Panama , Peru , Puerto Rico , Paraguay , Slovenia , El Salvador , Turkey , Trinidad & Tobago , Taiwan , United States , Uruguay , St. Vincent & Grenadines , Venezuela , U.S. Virgin Islands
Size
547KBUpdated On
2024-07-01Size
1939KBUpdated On
2024-05-07Size
1689KBUpdated On
2024-02-07Size
930KBUpdated On
2023-10-04Size
58KBUpdated On
2023-10-04Size
13KBUpdated On
2023-09-29Size
204KBUpdated On
2023-09-29Size
129KBUpdated On
2021-07-22Size
7512KBUpdated On
2024-02-22Size
109KBUpdated On
2023-10-04Size
148KBUpdated On
2023-10-04Size
74KBUpdated On
2022-10-07Size
192KBUpdated On
2021-08-27Size
194KBUpdated On
2019-07-30Free up space and secure power cords between rack-mount PDUs and attached IT equipment with this exclusive easy-to-use cord retention method. While these cords will fit into any standard IEC receptacle or power inlet; the "locking" feature is enabled only when used with APC AP8000 series Rack PDUs or IT equipment with built-in locking receptacles. These locking connectors reduce the probability of accidentally disconnecting cords and dropping loads.
APC Metered by Outlet Rack Power Distribution Units (PDUs) provide individual outlet power metering to enable energy optimization and circuit protection. Current metering provides real-time remote monitoring of connected loads. Metered by Outlet Rack PDUs provide power utilization data to allow Data Center Managers to make informed decisions on load balancing and right sizing IT environments to lower total cost of ownership. Metered by Outlet Rack PDUs include real power monitoring, a temperature/humidity sensor port, locking IEC receptacles, and ultra low profile circuit breakers. Users can access and configure Metered by Outlet Rack PDUs through secure Web, SNMP, or Telnet Interfaces which are complimented by APC Centralized Management platforms using InfraStruxure Central, Operations, Capacity, and Energy Efficiency.
Wide selection of Rack PDU power cords for a variety of IT equipment.
Wide selection of Rack PDU power cords for a variety of IT equipment.
This Temperature & Humidity Sensor is a Universal sensor that monitors temperature and humidity in your Data Center or Network Closet. IT has an RJ-45 connector. The cord length is 3.9m.
Free up space and secure power cords between rack-mount PDUs and attached IT equipment with this exclusive easy-to-use cord retention method. While these cords will fit into any standard IEC receptacle or power inlet; the "locking" feature is enabled only when used with APC AP8000 series Rack PDUs or IT equipment with built-in locking receptacles. These locking connectors reduce the probability of accidentally disconnecting cords and dropping loads.
Installs in various locations within the enclosure; for example, on the vertical mounting flanges and on the vertical 0U accessory channels. Provides mounting options for Rack PDUs and other small accessories.
Get an extension of factory warranty coverage beyond the original factory warranty term for peace of mind and protection from failure
Free up space and secure power cords between rack-mount PDUs and attached IT equipment with this exclusive easy-to-use cord retention method. While these cords will fit into any standard IEC receptacle or power inlet; the "locking" feature is enabled only when used with APC AP8000 series Rack PDUs or IT equipment with built-in locking receptacles. These locking connectors reduce the probability of accidentally disconnecting cords and dropping loads.
Wide selection of Rack PDU power cords for a variety of IT equipment.